Model Y Series: Episode 15: Tailor Welded Blanks, Body Side Inner, Welding Comparison MY-M3, Parts Raffle!
Welcome to episode 15 of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro walks us through what a tailor welded blank is, why it’s useful, where it’s used on the Model Y and where it wasn’t used on the Model 3.
Model Y Series: Episode 14: Rear Mega Castings and Structure, Trunk Tub, Potential Tow Location
This is episode 14 of Munro’s Tesla Model Y Performance teardown, where Sandy addresses viewer feedback and questions, a phone from call from Tesla, a review of the rear mega castings and structure, a comparison of the Model 3 and Model Y trunk tubs, and a potential strategy for the addition of a hitch.
Model Y Series: Episode 13: Comparing Model 3 eAC to Model Y Heat Pump
Welcome back to episode 13 of Munro’s Tesla Model Y Performance teardown, where, Munro & Associates CEO Sandy Munro compares the Model 3 eAC compressor and NVH provisions to the isolated heat pump on the Model Y.
Model Y Series: Episode 12: Floorpan, EPP Floor Risers, Commonality through Stanchions and Wiring Observations
This is episode 12 of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro shares observations on the geometry of the floorpan, strategies for raising the floor height, enablers for re-use of Model 3 components and initial thoughts on some of the high and low voltage wiring.
Model Y Series: Episode 9 – Aeroshields MY-M3, Hood Alignment, Engine Bay Rail Reinforcements
Episode 9 – Aeroshields MY-M3, Hood Alignment, Engine Bay Rail Reinforcements Welcome back to episode nine of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro compares the aeroshields between the Model Y and Model 3, offers commentary on hood alignment and more detail on engine bay rail reinforcements catered toward […]
Model Y Series: Episode 8 – Q&A from Comments and View of Things to Come
Episode 8 – Q&A from Comments and View of Things to Come Welcome back to episode eight of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro addresses a handful of viewer questions and gives a glimpse of what to expect next. During the five-minute video, Sandy discusses four common viewer […]
Model Y Series: Episode 7 – Front Impact Structure, Snap-Fit Lamp & Rotor Serviceability
Episode 7 – Front Impact Structure, Snap-Fit Lamp & Rotor Serviceability Welcome back to episode seven of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro takes a look at the front wheel envelope and shares an overview of the: Front impact structure: looking under the wheel well at the front […]
Model Y Series: Episode 6 – Wiring, Brakes, Quick-connects & Rear Body Structure Overview
Episode 6: Wiring, Brakes, Quick-connects & Rear Body Structure Overview Welcome back to episode six of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro provides an overview of the vehicle’s wiring, coolant lines, brakes and rear body structure. From the corrugated wrap over the local 12 volt wires and the […]
Model Y Series: Episode 5 – Suspension Overview
Episode 5: Suspension Overview Welcome back to episode five of Munro’s Tesla Model Y Performance teardown, where Munro & Associates CEO Sandy Munro provides an overview of the vehicle’s suspension configuration. Sandy’s initial overview is that the Tesla Model Y and Model 3 have similar suspension systems, but it’s obvious they’re not the same. Sandy […]